Herzberg HG-5029ORG Mode D'emploi page 6

Table Dough Types and Tools
Dough Type Tool
Heavy dough (e.g. Kneading
bread or shortcrust) hook
Medium dough (e.g. Mixing
crepes or cake batter) hook
Light dough (e.g.
cream, egg whites, beater
pudding)
NOTE:
• When selecting the speed setting, also refer to the
instructions in the recipe.
• Short time operation: With heavy dough do not operate
the appliance longer than 10 minutes and leave for 10
minutes to cool down.
After lowering the arm, the operation can only continue if you
press a speed setting again.
End Operation and Remove Bowl
1. Press the OFF button if the dough is kneaded. Disconnect
from the mains.
2. Push the arm (4) down. The arm rises.
3. Turn the mixing bowl one short turn anticlockwise to
remove it.
4.
5. To release the attachment from the drive shaft, push it up
and turn it a short distance clockwise. Then pull it out.
6. Clean the used parts as described under "Cleaning".
The mincer
Preparation
Please also refer to our overviews on page 3 and 74.
1. The access to the worm housing is protected by a cover (1)
on the appliance. Turn the cover clockwise to remove it.
2. Push the silicone coupling (15) onto the worm shaft (14).
3.
the worm housing.
Assembly of the accessories is described the following sec-
tions. Prepare the mincer according to your requirements.
Assembling the mincer (see Fig. A)
NOTE:
•
or a courser mincing plate.
•
oil.
Setting Amount
1-2 max. 1.2 kg
3-4 max. 1.2 kg
Egg 5-6 min. 200 ml
max. 1 l
Proceed as described under "Preparation".
4. Set the knife (16) onto the shaft of the worm with the sh
side facing outwards.
5. Select a mincing plate (17). Use the recesses on the plat
to insert it into the worm housing.
More details can be found under "Attach preassembled wo
housing".
Attach preassembled worm housing
6. Screw the ring nut (18) clockwise onto the worm housing.
7. Attach the pre-assembled worm housing to the appliance.
Position the worm housing with the arrow ( ) aligned with
(●) on the appliance. Turn to the upright position. The
arrow on the worm housing must be opposite the arrow on
CAUTION:
If you open and close the ring nut again after attaching
it, hold the worm housing securely with one hand on
accidentally come loose.
8.
above the arm (2).
Operation and Instructions for Use
WARNING: Risk of injury!
As soon as you turn the appliance on, the drive shaft (9)
turns. Do not touch the rotating drive shaft during operation!
NOTE:
• Cut the meat into pieces of around 2.5 cm. Make sure that
there are no bones or sinews in the meat.
• Short term operation: Do not operate the appliance for
longer than 10 minutes and then allow the appliance to
cool for 10 minutes.
6