Figures - Jetboil MIGHTYMO Instructions

FIGURES

3X
1.3
1.1
1.2
1.4
1.5
4X
Fig. 1 Fig. 3
2.3
3X
2.2
2.1
Fig. 2 Fig. 4
5
Fig. 8
3X
Fig. 5
3.2
3.1
Fig. 6 Fig. 9
7.1
7.2
Fig. 7 Fig. 10
ASSEMBLY
• Perform Leak Checks outside, in a well-ventilated area.
• Operate at least 1m/3.3ft away from combustible materials
and ignition sources.
• Before each use: Keep stove area clear and free from
combustible materials, gasoline, and other flammable
vapors and liquids.
• Do not obstruct the flow of combustion and ventilation air
to the stove.
• Do not use windscreen or outback oven; this can overheat
the fuel canister, resulting in explosion.
• Do not use an appliance which is leaking, damaged or which does
not operate properly.
• Always change gas canisters in a well ventilated location
away from any sources of ignition, such as naked flames,
pilot, electric heaters/equipment and away from other people.
Pot/cookware
is not included
1. Remove packed contents from pack bag (not shown).
2. Deploy pot support arms (3x) to fully open position (1.1).
3. Unfold the bail (1.2) from the valve body (1.3).
4. Close the control valve (7.1) (turn clockwise).
5. Check for debris in the valve connection (1.4), and that the O-Ring
is in place and in good condition before connecting to the stove.
Do not use the appliance if it has a damaged or worn
seal, this may result in gas leakage.
In temperatures below freezing, O-Rings may not
Pot/cookware
seal fully, resulting in a fuel leak.
is not included
WARNING
6