Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IN S TA L L AT I O N
Electrical Connections
WARNING
Before making electrical connections, verify the power
is turned off at the service panel.
IMPORTANT NOTE:
Refer to installation instructions pro-
vided with the blower assembly.
IN T E R NA L BL O W E R
Connect black to black and white to white with the
1
provided connectors, and connect the green/bare wire
to the ground screw.
Verify all wires are secure and not pinched, and reinstall
2
the cover.
Plug the blower power cord into the receptacle inside
3
the hood. Refer to the illustration below.
Turn on the power to the hood and verify light and
4
blower operation.
RECEPTACLE
ELECTRICAL
COVER
Electrical connections
8 | Wolf Customer Care 800.222.7820
IN - LIN E / RE MO TE B LO WER
Remove the connector from the end of the orange wire.
1
Connect the home supply. Connect black to black and
2
connect the green/bare wire to the ground screw.
Connect the blower supply. Connect black to orange,
3
all three white wires with the provided connectors, and
connect the green/bare wire to the ground screw.
Verify all wires are secure and not pinched, and reinstall
4
the cover.
Turn on the power to the hood and verify light and
5
blower operation.
ELECTRICAL
COVER
Electrical connections
Publicité
Table des Matières
