Braun 7 Serie Mode D'emploi page 9

Manual cleaning
Rinsing the shaver head under running water is
an alternative way to keep the shaver clean,
especially when travelling:
• Switch the shaver on (cordless) and rinse the
shaver head under hot running water until all
residues have been removed. You may use
liquid soap without abrasive substances.
Rinse off all foam and let the shaver run for a
few more seconds.
• Next, switch off the shaver, press the release
9
button to remove the Foil & Cutter cassette
8
and let it dry.
• If you regularly clean the shaver under water,
then once a week apply a drop of light
machine oil on top of the Foil & Cutter
cassette.
Alternatively, you may clean the shaver with a
brush:
• Switch off the shaver. Remove the Foil &
Cutter cassette
surface. Using a brush, clean the inner area of
the pivoting head. However, do not clean the
cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the
shaver and the Clean&Renew station with a
damp cloth, especially inside the cleaning
chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button
the housing, wait for a few seconds before
removing the used cartridge to avoid any
dripping. Before discarding the used cartridge,
make sure to close the openings using the lid of
the new cartridge, since the used cartridge will
contain contaminated cleaning solution.
Keeping your shaver in top shape
Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance, replace
the Foil & Cutter cassette
replacement symbol lights up on the shaver
z
display after about 18 months or when
cassette is worn.
The replacement symbol will remind you during
the next 7 shaves to replace the Foil & Cutter
cassette. Then the shaver will automatically
reset the display.
8
and tap it out on a flat
8
, when the
2
to open
Series
Ser ies
r e l e as e
Series 7
r e l e as e
click!
Series 7
r e l e as e
Series 7
r e l e as e
Series 7
r e l e as e
r e l e as e
new
old
9