Braun 7 Serie Mode D'emploi page 8

2
1
90°
8
How to use
Press the on/off switch
• The pivoting shaver head and floating foils
automatically adjust to every contour of your
face.
• To shave hard to reach areas (e.g. under the
nose) slide the shaver head lock switch
the back position to lock the pivoting head at
an angle.
• To trim sideburns, moustache or beard, slide
the pop-out long hair trimmer
Tips for the perfect dry shave
For best shaving results, Braun recommends
you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles
(90°) to your skin.
3. Stretch your skin and shave against the
direction of your beard growth.
Shaving with the cord
If the shaver has run out of power (discharged),
and you do not have the time to recharge it in
the Clean&Renew station, you may also shave
with the shaver connected to an electrical outlet
via the special cord set.
Cleaning
Automatic cleaning
After each shave, return the shaver to the
Clean&Renew station and proceed as described
above in the section «Before shaving».
All charging and cleaning needs are then
automatically taken care of. With daily use,
a cleaning cartridge should be sufficient for
about 30 cleaning cycles.
The hygienic cleaning cartridge contains
ethanol or isopropanol (specification see
cartridge), which once opened will naturally
evaporate slowly. Each cartridge, if not used
daily, should be replaced after approximately
8 weeks.
The cleaning cartridge also contains lubricants,
which may leave residual marks on the outer foil
frame after cleaning. However, these marks can
be removed easily by wiping gently with a cloth
or soft tissue paper.
w
to operate the shaver:
q
upwards.
0
to