Braun 7 Serie Mode D'emploi page 5

Description
Clean&Renew station
1
Cleaning fluid display
2
Lift button for cartridge exchange
3
Station-to-shaver contacts
4
Start button
D
Fast clean button
5
Cleaning program indicators
6
Station power socket
7
Cleaning cartridge
Shaver
8
Foil & Cutter cassette
9
Cassette release button
0
Shaver head lock switch
q
Pop-out long hair trimmer
w
On/off switch
e
– setting button (sensitive)
r
+ setting button (intensive)
t
Reset button
z
Shaver display
u
Shaver-to-station contacts
i
Shaver power socket
o
Travel case
p
Special cord set
Before shaving
Prior to first use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below:
Installing the Clean&Renew station
• Using the special cord set
station power socket
• Press the lift button
• Hold the cleaning cartridge
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fluid display
fluid is in the cartridge:
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
new cartridge required
p
, connect the
6
to an electrical outlet.
2
to open the housing.
7
down on a flat,
1
will show how much
p
1
2
5