Kimpex CLICK N GO 2 Instructions D'assemblage page 7

"CLICK N GO 2" PLOW ATTACHMENT
Arctic Cat – Prowler
Assembly of the V-Plate to the Attachment
plate
8) Assemble four (4) M8-1.25 x 25 mm carriage bolts
and four (4) M8-1.25 hex. nuts
the holes corresponding to the width of the four (4)
slotted holes of the attachment plate
first threads only in order to leave a space between
the head of carriage bolts
9) Assemble one (1) M8-1.25 x 20 mm hex. bolt
one (1) M8-1.25 hex. nut
V-plate . Tighten the bolt with an appropriate tool.
A
C
A
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2810518  A-2810518  Printed in Canada
ASSEMBLY INSTRUCTIONS
C
on the V-plate in
D A
. Screw the
01
and the V-plate .
C A
and
E
at the front centre of the
D
E
D
10) Assemble the V-plate
by first aligning the rear carriage bolts
front carriage bolts .
C
11) Once the carriage bolts
the slotted holes of the attachment plate
it well using an appropriate tool.
Position of the Push Frame Hook Assembly
Install the push frame hook assembly in Position 3. Refer
to the instructions for the push frame for the assembly
procedure. It is possible that the position must be
changed to fit the winch installed on the vehicle.
374145
KIMPEX NO.
on the attachment plate
A
, then the
C
inserted to the bottom of
C
, tighten
01
01
3