Kimpex CLICK N GO 2 Instructions D'assemblage page 6

"CLICK N GO 2" PLOW ATTACHMENT
Arctic Cat – Prowler
Plow Attachment Installation Procedure
1) Assemble the two (2) spacers
attachment plate using two (2) M8-1.25 x 25 mm
01
carriage bolts and two (2) M8-1.25 hex. nuts
C
Tighten the first threads only.
2) Remove the two (2) bolts holding the skid plate of
the vehicle.
3) Assemble the front of the attachment plate
the vehicle frame with the bolts removed in the
previous step.
4) Center the attachment plate
frame using a ruler.
5) Drill in the skid plate of the vehicle with the drill
bit provided in the kit while using the attachment
F
plate as a reference.
01
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2810518  A-2810518  Printed in Canada
ASSEMBLY INSTRUCTIONS
to the rear of the
02
.
D
Front of
the vehicle
on
01
with the vehicle
01
6) Insert the four (4) square bend U bolts
the frame and floor of the vehicle, pass in the holes
drilled in the previous step, and secure with
eight (8) M8-1.25 hex. nuts
connect the frame and the skid plate of the vehicle,
the spacer and the attachment plate
02
are inserted upwards to the front, and
B
downwards to the rear.
02
01
7) Tighten all bolts and nuts assembled so far with an
appropriate tool.
374145
KIMPEX NO.
Front of
the vehicle
between
B
. Each U-bolt must
D B
. U-bolts
01
B
B
Front of
the vehicle
D
2