Best DD0130SS Mode D'emploi page 11

OPERATION
BUTTONS
LED's
ICONS
Press this BUTTON... when CHIMNEY is...
Up/Down Down
Up/Down Up
High [ 3 ] Up
High [ 3 ] Up
High [ 3 ] Down
Med [ 2 ] Up
Med [ 2 ] Up
Med [ 2 ] Down
Low [ 1 ] Up
Low [ 1 ] Up
Low [ 1 ] Down
Delay * Up
Delay * Up
Delay * Up
Delay * Up
Delay * Up or Down
* Heat Sentry is disabled in Delay mode
When this BUTTON
LED is illuminated... and CHIMNEY is...
Filter Up or Down
Press this BUTTON... when CHIMNEY is...
Filter Up or Down
When this BUTTON
LED is flashing... and CHIMNEY is...
Med [ 2 ] or High [ 3 ] Up
LED flashing
Press this BUTTON
and hold for 1 second... when LED is...
Med [ 2 ] Flashing
High [ 3 ] Flashing
** Press any button to re-active Heat Sentry.
and BLOWER is... RESULT
Off Chimney rises / Blower turns On to last speed used
On or Off Chimney lowers / Blower turns Off
On / Low or Med Blower speed to High.
On / High Blower turns Off / Chimney remains Up
Off No action
On / Low or High Blower speed to Med
On / Med Blower turns Off / Chimney remains Up
Off No action
On / Med or High Blower speed to Low
On / Low Blower turns Off / Chimney remains Up
Off No action
On / High Blower on High 5 min. > Low 5 min. > Off
Chimney remains Up / Delay LED flashes & Speed LED's illuminate
On / Med Blower on Med 5 min. > Low 5 min. > Off
Chimney remains Up / Delay LED flashes & Speed LED's illuminate
On / Low Blower on Low 5 min. > Off (all LED's Off)
Chimney remains Up / Delay LED flashes & Low LED illuminates
On / in Delay Mode Delay Mode cancelled
Off No action
and BLOWER is... RESULT
On or Off Filter LED illuminates as a reminder to clean Filters (approx. every 30 hours).
Pressing Filter Button turns Off illuminated Filter LED and resets Filter-use
timer.
and BLOWER is... RESULT
On or Off Pressing Filter button when Filter LED is not illuminated - No action
and BLOWER was... RESULT
On / Low or Med a. Exhaust temperature is higher than anticipated - Heat Sentry mode activated.
b. Blower increases to next highest speed.
c. Blower speed LED flashes on / off.
d. Blower speed may increase, decrease, or stay at current speed based on
exhaust air temperature.
e. When Blower speed returns to original setting - Blower speed LED stops
flashing.
f. Unit no longer in active Heat Sentry mode.
and BLOWER is... RESULT
On / any speed Heat Sentry mode disabled. **
On / any speed Heat Sentry mode disabled. **
Downdraft Ventilators
Page 11