Basic Configuration; Inputs And Outputs - AKO 16624 Guide Rapide

Basic configuration

Description
B00
Delay of all functions on receiving power supply
Bcn
B01 Cold room light timing
Function of password
B10
1=Block access to parameters
PAS Access code (Password)
B20
MODBUS address
Communication speed:
B21
B22
Acoustic alarm enabled 0= No 1=Yes
Lower display function 0=Shows moisture 1=Shows the time (1)
B23
2=Shows moisture and the time alternately (1)
UNT
Work units
EP
Exit to level 1

Inputs and outputs

Description
In0
Connected probes 1=Probes S1 and SH (Cold room temperature + moisture)
I00
2=Probes S1, S2 and SH (Cold room temp. + evaporator temp. + moisture)
Configuration of digital input 1
0= Deactivated
I10
3=Severe external alarm
5=Low pressure switch
Polarity of the digital input 1
I11
0=Activates on closing contact; 1=Activates on opening contact
Configuration of digital input 2
I20
1=Door contac
4= Temp. control selector / temp. + moist.
Polarity of the digital input 2
I21
0=Activates on closing contact; 1=Activates on opening contact
Configuration of input 3
1=Door contac
I30
4=Temp. control selector / temp. + moist.
6=Product temperature (HACCP alarm control)
Polarity of the input 3
I31
0=Activates on closing contact; 1=Activates on opening contact
Configuration of relay AUX1 0=Deactivated 1=Compressor/Resistor sump
O00 2=Light
4=Same status as COOL relay
* According to wizard.
0=Inactive
2=Block keypad
0=9600 bps 1=19200 bps
2=38400 bps 3=57600 bps
0=ºC 1=ºF
1=Door contact
4=Temp. control selector / temp. + moist.
0= Deactivated
2=External alarm 3=Severe external alarm
5=High pressure switch for Hot Gas
0= Deactivated
2=External alarm 3=Severe external alarm
5=Log temperature
3=Virtual control
5=Same status as unit
(1) Only available with the CAMM module installed.
22 22
Values Min.
Min.
Min.
bps
Values Min.
2=External alarm
1662H411 Ed.06
Def. Max.
0 0 255
0 0 999
0 0 2
0 0 99
1 1 247
0 0 3
0 1 1
0 0 2
0 0 1
Def. Max.
1 2 2
*
0 5
*
0 1
*
0 5
*
0 1
0 3 6
0 0 1
*
0 5