Initial Configuration - AKO 16624 Guide Rapide

Contrôleur de température et d'humidité pour chambre froide
Masquer les pouces Voir aussi pour 16624:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Initial configuration

The first time the unit receives the power supply, it will enter into ASSISTANT mode. The lower display will show the
message In1 flashing with 0.
Step 1: Cold regulation type
1
AUX
Select the most suitable option based on the type of
installation to be carried out and press SET. The available
options are shown in the table on the following page.
Step 2: Moisture regulation type
2
AUX
Select the most suitable option based on the type of
installation to be carried out and press SET. The available
options are shown in the table on the following page.
If this is not the first time you run the wizard, after completing the last step the display will show the message dFp
(default parameters). You may choose between two options:
0: Only change the parameters which affect the wizard. The other parameters will remain the same.
1: All parameters return to their factory setting except those which have been modified by the wizard.
The configuration wizard will not reactivate. To reactivate it, activate the Stand-By mode (by pressing the m key
for 3 seconds) and wait until the unit completely halts regulation (the m indicator will light up permanently)
and press in this order the following keys (one after the other, not at the same time) N, Q, SET.
STAND-BY
If the regulation cannot be instantly stopped due to its configuration, a controlled stop process starts
and the m icon flashes. To stop the controlled stop process and force the step to Stand-by, press the
Stand-by key again for 3 seconds.
Step 3: Temperature Set Point
3
AUX
Use keys N and Q to enter the desired Set Point value
and press SET.
Step 4: Moisture Set Point
4
AUX
Use keys N and Q to enter the desired moisture Set
Point (SPH) value and press SET.
17 17
1662H411 Ed.06
AUX
AUX
AUX

Publicité

Table des Matières
loading

Table des Matières