Kohler K-3519 Instructions D'installation page 4

Wax Seal
Bottom of Bowl
Closet Flange
2. Install the New Toilet
CAUTION: Risk of trap seal loss in back-to-back
installations. To prevent a trap seal loss, back-to-back toilet
installations must be connected to a vertical stack using one
of the following three fittings: double fixture, double
combination wye and 1/8 bends, or double wye and 1/8
bends.
Install or relocate the supply and outlet as necessary to conform
to the roughing-in dimensions.
Install a supply shut-off valve.
Lay the toilet down onto a padded surface.
From the bottom of the toilet, firmly press a new wax seal around
the toilet outlet.
Remove the temporary rag (if used) from the toilet flange hole.
Align and lower the toilet over the flange and T-bolts.
IMPORTANT! Do not lift or rock the bowl after placement. If you
break the watertight seal, you must install a new wax seal.
Apply your full body weight around the toilet to set the seal.
CAUTION: Risk of product damage. Handle with care.
Vitreous china can break or chip if the bolts and nuts are
overtightened, or if the product is handled carelessly.
Carefully tighten the nuts.
1054184-2-B
Bolt Cap
Bolt Cap Base
T-Bolt
T-Bolt
4
Nut
Washer
Kohler Co.