DK2 AC20G Manuel De L'utilisateur page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles



WARNING! Motors, electrical equipment and controls can cause electrical
arcs that will ignite a flammable gas or vapor. Never operate or repair in
or near a flammable gas or vapor. Never store flammable liquids or gases
in the vicinity of the compressor.

CAUTION! RISK OF BURNS: Compressor parts may be hot even if the
unit is stopped. There are surfaces on your air compressor that while in
operation and thereafter can cause serious burns if touched. The
equipment should be allowed time to cool before any maintenance is
attempted. Items such as the compressor pump and the outlet tube are
normally hot during and after operation.
8. Keep fingers away from a running compressor, fast moving and hot parts will cause
injury and/or burns.
9. If the equipment should start to abnormally vibrate, STOP the engine/motor and check
immediately for the cause, vibration is generally a warning of trouble.
10. To reduce fire hazard, keep engine/motor exterior free of oil, solvent, or excessive
grease.

WARNING! Never remove or attempt to adjust safety valve. Keep safety valve free from
paint and other accumulations.

DANGER! RISK OF BURSTING: Always drain the air compressor tank
daily or after each use. If the tank develops a leak, then replace the air
compressor. Never use the air compressor after a leak has been found
or tried to make any modifications to the tank. Never modify the air
compressor's factory settings which control the tank pressure or any
other function. Welding drilling, or any other modification will weaken the
tank resulting in damage from rupture or explosion. Always replace worn
or damaged tanks.

WARNING! Drain liquid from tank daily.
11. Tanks rust from moisture build-up, which weakens the tank. Make sure to drain tank
regularly and inspect periodically for unsafe conditions such as rust formation and
corrosion.
12. Fast moving air will stir up dust and debris, which may be harmful. Release air slowly
when draining moisture or depressurizing the compressor system.

WARNING! RISK OF EXPLOSION OR FIRE: Never operate the
compressor near combustible materials, gasoline or solvent vapors. If
spraying flammable materials, locate the air compressor at least 50m
away from the spray area. Never operate the air compressor indoors or
in a confined area. Do not spray flammable materials in vicinity of open
flame or near ignition sources including the compressor unit.
v.221102 | 9

Publicité

Table des Matières
loading

Produits Connexes pour DK2 AC20G

Table des Matières