Break-In Procedure; Safety Valve; Regulator Knob; Tank Pressure Gauge - DK2 AC20G Manuel De L'utilisateur

BREAK-IN PROCEDURE

No break-in procedure is required by the user. This product is factory tested to ensure proper
operation and performance. Compressor must always be turned ON or OFF using pressure switch.
Never turn the machine ON or OFF using power source.


NOTICE! MOISTURE IN COMPRESSED AIR: Moisture in compressed air will form into
droplets as it comes from an air compressor pump. When humidity is high or when a
compressor is in continuous use for an extended period of time, this moisture will collect
in the tank. When using a paint spray or sandblast gun, this water will be carried from the
tank through the hose, and out of the gun as droplets mixed with the spray material. This
condensation will cause water spots in a paint job, especially when spraying other than
water based paints. If sandblasting, it will cause the sand to case and clog the gun rendering
it ineffective. A filter in the air line (MP3105), located as near to the gun as possible, will help
eliminate this moisture.

SAFETY VALVE

WARNING! DO NOT REMOVE OR ATTEMPT TO ADJUST THE SAFETY VALVE: This valve
should be checked under pressure occasionally by pulling the ring by hand. If air leaks
after ring has been released, or valve is stuck and cannot be actuated by ring, it MUST be
replaced.

REGULATOR KNOB

(See Fig.3)
1. This knob controls air pressure to an air-
operated tool or paint spray gun.
2. Turn clockwise to increase air pressure at
outlet. When desired pressure is reached,
lock with nuts.
3. To lower air pressure at outlet, turn counter-
clockwise.
4. Turn fully counter-clockwise to shut off flow
of air completely then push knob down.

TANK PRESSURE GAUGE

This gauge shows pressure in tank indicating compressor is building pressure properly.
16 | AC20G(H) man.
FIGURE 3: PRESSURE REGULATING VALVE / SOUPAPE DE RÉGULATION DE PRESSION