Preparation; Precautions; Setting Up The Unit - Sony VID-P110 Mode D'emploi

Preparation

Precautions

• Unplug the VID-P110 from the wall outlet when it is
not being used for a long period of time. To
disconnect the cord, pull it out by grasping the plug.
Never pull it out by the cord itself.
• The fluorescent lamps can get hot during operation.
Do not touch the lamps during operation and when
collapsing the VID-P110.
• Clean the cabinet with a soft cloth lightly moistened
with a mild detergent solution. Never use any type of
solvent such as alcohol or benzine, which might
damage the finish.
• Clean the lens with an air spray or soft dry cloth,
taking care not to scratch it.
• When the fluorescent lamps flash or get darkened, the
fluorescent lamps should be replaced with new ones.
In this case, contact your Sony dealer.

Setting Up the Unit

1
Lift up the camera stand while keeping the
UNLOCK lever pressed down.
Camera stand
2
Adjust the camera to the direction shown by the
arrow so that the lens faces downwards.
10
3
4
UNLOCK lever
Open both arm lights until they fix in place.
Arm light
Connect the power cord to the AC IN connector on
the rear panel.
Arm light