Urmet 1092/275H Guide Rapide page 6

ENGLISH
INSTALLATION
1. Before start installation, check that all the devices to be connected are not powered.
2. Remove the protection dome by unscrewing with the provided spanner the three locking screws.
Make 3 fixing holes (for false-ceiling mounting, make also a 15mm diameter hole for passage of
cables), using the minidome as drilling template.
3. Fix the minidome to the surface with the provided screws.

Note: If the dome is not false-ceiling mounted, unscrew the cables passage screw on the dome side.
4. Connect the video output to the selected terminal device.
5. Connect the power JACK to the power supply unit and power-on the camera
6. Adjust lens angle, slant and rotation, in order to capture correctly the selected images
7. Loosen with a slotted screwdriver the adjusting rings for focus and varifocal adjustment.

Rotate to WIDE "W" to zoom out the subject (consequently, field and viewing angle are
increased).

Rotate to TELE "T" to zoom in the subject (consequently, field and viewing angle are reduced).

Rotate to NEAR "N" to adjust focus of a near subject.

Rotate to FAR "∞" to adjust focus of a distant subject.
6
360°
FIXING HOLES
ATTENTION.
reflections on the image it's
Max 75°
strongly recommended not to
overtake the indicated slant
360°
To avoid
DS1092-222A