Installation And Ventilation - Engel SB30F-N-U Manuel Du Propriétaire

5. Installation and Ventilation

Installation
1) Make sure the refrigerator in fitted horizontally. When installing in
the Vehicle, make sure the refrigerator is not fitted to an unstable
position.
2) Make sure to install the refrigerator where air flow is available. If
the cooling unit air flow is contaminated, the cooling system will
be degraded.
3) Avoid direct Sunlight, heat from a stove, or anything related to
heat. If you install the refrigerator near a gas stove, a heater, or
any other heat generating appliances, or place in direct sunlight,
the cooling performance will be affected. And there is a risk of
discoloration or deformation.
4) Avoid installing the refrigerator close to a kitchen sink or water
faucet. If installed in locations subject to water the electrical
circuits and other parts may be effected.
5) To achieve good cooling performance and less current
consumption, adequate ventilation for the refrigerator is needed.
a) In the drawing below (Fig.1) :
the ventilation air will flow in the direction of the arrow.
b) Make sure NOT to block the intake vent and outtake vent of
the compressor unit.
c) Recommended vent size :
vertical length of 20cm and side length of 8cm.
If blocked, the cooling performance will be affected. And
there is a risk of the failure of the cooling system.
- 11 -