Kohler Armoire murale Instructions D'installation page 4

2. Install the Hanger
6-1/2''
(165 mm)
With assistance, lift and place the cabinet in position against the finished wall.
Verify that the cabinet is level, then mark the top and centerline of the cabinet.
Carefully set the cabinet aside onto a padded surface.
Measure 6-1/2" (165 mm) down from the top, and draw a second mark.
Align the center of the hanger with the centerline, and the bottom edge aligned with the lower mark.
Verify that the hanger is level.
NOTE: If installing hanger into wall studs, new 1/8" pilot holes aligned with the wall studs may need to be drilled into the
wall hanger. In addition, a 3/8" diameter, 1/4" deep counterbored hole will need to be added for the screwhead to sit flush.
Drill 1/8" holes into the wall through the pilot holes in the hanger.
Secure the hanger onto the wall with the wood screws (provided).
1384740-2-A
4 Kohler Co.