Specifications; Maintenance And Service - Tripp-Lite UBC41 Manuel Du Propriétaire

Specifications

Input Voltage
Input Frequency
Current (Without Load)
Maximum Output Current
Maximum Efficiency in Max Power
Output Voltage
Maximum Ampere Imax
(Input Voltage Switch Set to "High")
Minimum Ampere Imax
(Input Voltage Switch Set to "Low")
Maximum Output Charging Power
Voltage Sensor Startup Position
Charging Range
Average Charging Voltage (Vblk)
Floating Charging Voltage (Vflt)
Protection Functions
Voltage / Current Precision
Longest Floating Charging Time
Operating Ambient Temperature
Operating Ambient Humidity
Cooling System
Average Internal Temperature
Dimensions [L x W x H]
Weight
Note: If the battery voltage is below the charge range, the charger may not run (turn on). For example, this can occur when the terminal voltage for a 12V battery is less
than 8V.

Maintenance and Service

Maintenance
Your Tripp Lite Charger requires no maintenance and contains no user-serviceable or replaceable parts, but should be kept dry at all times.
Periodically check, clean and tighten all cable connections as necessary, both at the unit and at the battery.
Service
Your Tripp Lite product is covered by the warranty described in this manual. A variety of Extended Warranty and On-Site Service Programs
are also available from Tripp Lite. For more information on service, visit www.tripplite.com/support. Before returning your product for service,
follow these steps:
1. Review the installation and operation procedures in this manual to insure that the service problem does not originate from a misreading
of the instructions.
2. If the problem continues, do not contact or return the product to the dealer. Instead, visit www.tripplite.com/support.
3. If the problem requires service, visit www.tripplite.com/support. Click "Product Returns" from the left-side drop down or menu bar, then
select the "Request Return (RMA)" link. From here you can request a Returned Material Authorization (RMA) number, which is required
for service. This simple on-line form will ask for your unit's model and serial numbers, along with other general purchaser information.
The RMA number, along with shipping instructions will be emailed to you. Any damages (direct, indirect, special or consequential) to the
product incurred during shipment to Tripp Lite or an authorized Tripp Lite service center are not covered under warranty. Products shipped
to Tripp Lite or an authorized Tripp Lite service center must have transportation charges prepaid. Mark the RMA number on the outside
of the package. If the product is within its warranty period, enclose a copy of your sales receipt. Return the product for service using an
insured carrier to the address given to you when you request the RMA.
12V
30A
10A
450W 900W
8 ~ 14.8V 16 ~ 29.6V
14.5V
13.3V 26.6V
Full Load: -4° ~ 140°F (-20° ~ 60°C)
Maximum 95% RV , Not Condensing
Automatic adjust fan according to internal temperature
11.8 x 8.8 x 4 in. (300 x 223 x 101 mm)
5
100V ~ 240V Manual Switch
50 / 60 Hz
< 0.1A
< 15A
> 80%
24V 36V
30A 25A
10A 10A
1000W
5V
30 ~ 39.9V
29V 42.6V
39.9V
Short Circuit Protection
Reverse Connection Protection
Internal Overheat Protection
< 5%
No Limitation
<150°F (< 70°C)
9.9 lb. (4.5 kg)
48V
15A
7A
900W
40 ~ 60V
56.5V
53.2V