Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fiche technique
ET 04848
PRO
SOD CUTTER
STORAGE INSTRUCTIONS
WARNING
!
To prevent possible explosion or ignition of vapor-
ized fuel, do not store equipment with fuel in tank or
carburetor in enclosure with open flame (for example,
a furnace or water heater pilot light).
Daily Storage
1. Check engine oil level and air filter element daily.
2. Check oil level in hydro drive. Hydro drive uses
20W50 oil.
3. Close fuel valve at bottom of fuel tank.
4. Clean cutting blade (grass, dirt, etc.).
Extended Storage
Before the equipment is put into storage for any
period exceeding 30 days:
1. Drain all fuel from fuel tank and lines (use a
hose or fuel line, routed from fuel tank shut-off to
proper container).
2. Start engine and run until all fuel is used from
the carburetor float bowl.
3. While engine is warm, check the transmission
oil and refill with the proper weight of oil corre-
sponding to the season when the equipment will
next be used.
4. Remove the spark plug and squirt a small quan-
tity of engine oil into the cylinder. Turn the engine
over a few times to distribute the oil.
5. Lubricate all lubrication fittings.
6. Clean and oil cutting blade to prevent rust.
To put equipment into operation after an
extended storage:
1. Fill fuel tank with clean fresh fuel.
2. Check crankcase oil level, and start engine.
3. Check fuel system for fuel leaks.
PROTOUMAT - 35 route de Colmar, 67600 Sélestat
SIRET : 444 448 898 00015
WARNING
!
When replacement parts are required, use genuine
Classen parts or parts with equivalent characteris-
tics, including type, strength and material. Failure to
do so may result in product malfunction and possible
injury to the operator and/or bystanders.
Carbon monoxide present in the exhaust is an odor-
less and deadly gas. Never start or run the engine
inside where exhaust fumes can collect. Provide
enough fresh air to keep fumes from getting too
strong.
Replace any warning decal that becomes illegible
immediately.
Tél. : 03 88 08 65 06
Fax : 03 88 08 67 39
STORAGE
5
contact@protoumat.fr
32
www.protoumat.fr
Publicité
Table des Matières
