Makita ML104 Manuel D'instructions page 5

CAUTION:
• Always install the battery cartridge fully until the red
indicator cannot be seen. If not, it may accidentally fall
out of the luminaire, causing injury to you or someone
around you.
• Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being inserted
correctly.
Use of non-genuine Makita batteries, or batteries that
have been altered, will void the Makita warranty for the
Makita tool and charger.
Indicating the remaining battery capacity
(Fig. 2)
(Only for battery cartridges with "B" at the end of the
model number.)
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
Indicator lamps
Lighted
NOTE:
• Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
Overdischarge protection
When the battery capacity is not enough, the light goes off
automatically. In this case, remove the battery from the
tool and charge the battery.
Light switch operations (Fig. 3)
CAUTION:
• Do not look in the LED light or see the source of light
directly.
Press the light switch as shown below to change modes.
Main LED (20 pcs.) light up
Main LED (5 pcs.) light up*
Sub LED (1 pc.) light up
OFF
Remaining capacity
Off
75% to 100%
50% to 75%
25% to 50%
0% to 25%
* The LEDs on the opposite side of the light switch light
up.
Metal hook (Fig. 4)
Pivot the metal hook upright before using it.
The hook can be turned at 360° and removed.
Connecting USB devices (Fig. 5)
CAUTION:
• Connect only devices which are compatible with the
USB power supply port. Otherwise it may cause
malfunction to the battery holder.
This luminaire (with the battery) can work as an external
power supply for USB devices.
Open the cover and connect the USB cable (not included)
with the power supply port of the battery holder. And then
connect the other end of the cable with the device.
Press the USB power supply switch. The switch lights in
green and the USB power supply port (with the battery)
starts to supply DC5V, 2.1A at a maximum. Press the
USB power supply switch again to turn off the power
supply.
NOTE:
• Before connecting USB device to the luminaire (with
the battery), always backup your data of USB device.
Otherwise your data may be lost by any possibility.
• The luminaire may not supply power to some USB
devices.
• When not using or after charging, remove the USB
cable and close the cover.
• To save the battery power, the USB power supply
switch will automatically turn off when; 30 minutes is
past since the power supply is finished; or the power
supply is not performed for 30 minutes.
• If the remaining battery capacity become lower, the
USB power supply switch will turn off and the power
supply will stop to prevent overdischarging of the
battery. In this case, charge the battery or replace with
new one.
Magnet Attachment (optional accessory)
(Fig. 6, 7)
Attach the magnet attachment by tightening the screw.
When attaching the tool with the magnet attachment, use
a string to fix the magnet attachment.
WARNING:
• Do not bring the magnet attachment closer to precision
equipment such as electronic device, clock, watch, or
IC card. The magnetic force may affect them.
• Do not use the magnet attachment near the heart
pacemaker. There is a risk of malfunction.
NOTICE:
Before the attachment, make sure that the magnet can be
attached to the desired metal, and there is enough space
for the attachment. After the attachment, make sure that
the tool is firmly fixed.
NOTICE:
• If the magnet attachment is attached to the material for
a long period, the surface of the material may be
damaged depending on the use conditions.
5