Jeulin VTT method Mode D'emploi page 6

®
VTT method
®
VTT Ergolab Burette sensor
Ref :
472 043
ENGLISH
1 Description
®
The VTT Ergolab Burette sensor associated with the electronic Ergolab SA
burette (Part no.: 701 338, not supplied) enables the computerization of
volume measurements.
(2) Zero adjustment
potentiometer
(1) Connection to the
console
2 Use
2.1 Interfaces
This sensor works with the VTT console or ESAO Primo.
2.2 Connecting the sensor to the VTT
The sensor is connected using the connector located at the back of the box
of the VTT console or the front face of the ESAO Primo:
•
Place the sensor in line with the selected measurement channel.
•
Engage the sensor on the console guide.
•
Follow the guidance system of the VTT
•
Engage it fully.
(4 ) Safety banana sockets for
connecting to the Ergolab SA
electronic burette
(3) Gradient adjustment
potentiometer
®
5
®
console
console.