IVIGO EHR5012 Instructions De Montage Et Manuel D'utilisation page 12

2. INSTALLATION INSTRUCTIONS
2.1 Standard Model
1. Open the packing box and take out the radiator with
its protective nylon cover. Tear the protective nylon
cover outside the box without giving any harm to the
appliance and take out the assembly unit.
2. Correct space has to be measured in order that the
connection cord can easily be connected to the electric
socket. After determination of the installation area, the
holes must be marked according to the method shown
in Figure 4.
3. After marking the points according to Figure 4, the
holes will be drilled by a 010 mm drill and the plastic
dowels (see figure 3-part "A") that are in the installation
items are inserted to these holes.
4. Attach the anchors(4 pieces) (see figure 3 - part"B")
onto plastic dowels with the washer (see figure 3 -part
"C ) and the screw (see figure 3 - part "D")
5. Insert the plastic parts (see figure 3 - part "E") into the
lower installation bracket (see figure 3 - part "G") and fix
the installation brackets (see figure 3 - part "F-G")on the
tubes with the screw (see figure 3 - part "H").
6. Attach the installation brackets(4 pieces) on the
towel warmer and fix the towel warmer on the wail by
screwing (see figure 3 - part "I") the installation brackets
onto anchors (see figure 3 - part "B") on the wall.
Note: Protect the control unit against impacts and
crashes during installation.
Ø6 x 150 mm
8