Wireless Reception Module - Abus FUMO50020 Instructions D'installation

The jumpers are allocated as shown here:
12V
0V
6.3.6

Wireless reception module

Function 6 / LED 6
When used as a wireless reception module, a connected system can
be expanded by up to eight wireless components per module using
the accessory module. The accessory module serves as a wireless
receiver for these eight wireless detectors. The relay outputs are
connected to the zone inputs of the connected centres. In addition
to alarms, tamper and detector faults are also transmitted
(battery fault, supervision failure, jamming etc.). Each of four
wireless detectors activate one relay output. All tamper messages
activate the third relay output; whilst fault messages activate the
fourth relay output.
To use the accessory module as a wireless receiver module, proceed
as follows:
1. Select the appropriate switch position for dip switches 2, 3 and
4 (see point 5.5).
In the main programming menu, select item 7 (Function). LED
7 lights up.
Confirm by pressing SET.
In the submenu of item 7 (Function), select function 6 with the
SELECT button.
LED 6 lights up.
Confirm by pressing SET.
LED 7 lights up again.
Exit the programming mode by pressing ESC/DEL.
The LED for the power supply lights up/flashes and the fault
LED lights up. The accessory module beeps at short intervals.
Close both tamper contacts of the WAM and wait until it emits
a double tone.
2. Train the wireless detector to the WAM.
To do this, proceed as follows:
- Set dip switch 1 to ON.
- In the main programming menu, select item 1 (LED 1 lights
up).
- Confirm by pressing SET.
- The LEDs show the state of the trained wireless detectors.
47