neopulse NP1 MICRO Notice D'utilisation page 21

3
4
5
3. Filling the tank: remove the power cord from the device before
filling the tank (1) and using the product. Remove the tank from the
base unit and fill the tank with lukewarm water. Then place the tank
in position on the top of the base unit and clip the valve side (11)
into the base hole, press strongly. Make sure you have put the water
tank in a stable position.
4. Tip insertion and removal: Insert the tip (12) into the center of the
rotary control button (10) on the top of the dental water jet handle.
Press firmly until the tip clicks into place. To remove the tip from
the handle, press the eject button (9) and remove the tip from the
handle. CAREFUL: Do not press the tip ejection button while the
device is on.
5. Pressure settings: Adjust the pressure by sliding the pressure
control button (8), up for more pressure or down to decrease the
pressure. Begin with the lowest setting and increase the pressure as
preferred.
E N
21