Changing The Transmitter Communications Channel - Seac Guru HP Manuel De L'utilisateur

Changing the Transmitter communications channel

If interference with other Transmitters occurs, you will need to change the communications channel (TX ID).
Each Transmitter has 31 channels. The channel is assigned randomly, and the channel assigned is saved to memory. It is not
changed until the Transmitter's battery dies or you perform the following procedure to change the TX ID.
PROCEDURE:
Connect the Transmitter
(off) to a first stage.
After you change the TX ID, you will need to pair the devices again, after selecting the RESET command on the GURU.
Select RESET (the TX ID is set automatically to OFF). Then pair the devices again as described in the correct chapter in this manual.
Open the tank.
Press the second stage purge button
Close the tank.
and completely drain all pressure from
the Transmitter before it completes
the start-up phase. Wait 30 seconds
before turning the Transmitter on
again.
English 11