Starting Of A Programme; How To Change A Running Programme; Subsequent Addition Of Dishes - Pkm DW12A++7TI Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.1 Starting of a programme

1. Fill the lower rack first.
2. Pour the dishwasher detergent and the water softener (=dishwasher salt) in the
relevant containers.
3. During operation the appliance must be supplied with water ( full water
pressure).
4. Close the door properly while pressing gently. When the door closes properly
you will hear a light KLICK.
5. Press the PROGRAM button to select a programme.
6. Press the OFF button when the programme has ended. Open the door.

6.2 How to change a running programme

You can only change a programme when it has run a short period of time.
Otherwise the detergent has dissolved and the dishwater has been
drained. In such a case you must refill the detergent container.
1. Press the ON/OFF button to cancel the running programme..
2. Switch on the appliance again.
3. Set the desired new programme.
4. Close the door.
When you open the door while the appliance is operating, the appliance will stop
operating. The display indicates the code E1. When you close the door again, the
appliance will start operating after 10 seconds.
The 6 control lights indicate the status of the appliance.
a) One light is on = the relevant programme is running.
b) One light flashes = Pause - mode.

6.3 Subsequent addition of dishes

You can put dishes later in the appliance unless the detergent container has opened.
1. Open the door slightly to stop operation.
2. You can open the door completely after the rotating spray arms stopped
operation.
3. Now you can add dishes.
4. When you close the door, the appliance starts operating after 10 seconds.
70

Publicité

Table des Matières
loading

Table des Matières