Important; Installing The Winch Hook - Bercomac 700448-1 Manuel Du Propriétaire

Hook the turnbuckles (item 1) into the brackets (item
2) or the lift straps (item 3) and adjust them so that
the subframe is centered under the vehicle.
Tighten firmly the turnbuckles to stiffen the vehicle's
suspension.
IMPORTANT: After adjusting the turnbuckles, firmly
tighten the nuts on the wheel supports of the vehicle.
Make sure to block the nuts with the original locks.

INSTALLING THE WINCH HOOK

Install the winch cable (item 1).
NOTE:
If the vehicle's winch is higher than 20" from the
ground, install the sleeve (item 2) in the top hole
with a hex. bolt 1/2" x 2 1/4" (item 3) and a nylon
insert lock nut. Tigten firmly.
If the vehicle's winch is lower than 20" from the
ground, install the sleeve (item 2) in the bottom
hole (item 4) with a hex. bolt 1/2" x 2 1/4" (item 3)
and a nylon insert lock nut. Tigten firmly.
Install the winch's hook on the bracket (item 5) by
threading it behind the lever as shown and then
thread the cable over the sleeve as shown.
ASSEMBLY
Hook the turnbuckles to the brackets or to the lift
straps
11
Install the winch hook