Declaration Of Conformity - Ama Magico EMC50 Notice D'emploi

8. MAINTENANCE AND CLEANING
Danger !! Always wear protective
gloves
Any repairs should only be made by skilled technical
personnel, using original spare parts
Before examining or cleaning the machine, make sure the
mains power is shut off
Remove the sieve (pict.5-6), remove any remaining cereal,
clean the blades and other parts of the grinding chamber
with a brush or cloth, remove residues and fit the desired
sieve back on (pict.7-8).
Danger !! For cleaning, do not use liquids.
IMPORTANT: to ensure the good operation of the
electric mill, the inside parts are best cleaned every
time after use.
If the blades or other parts are found to be worn or damaged,
contact your nearest dealer to have them replaced.
The electric mill is equipped with safety devices that
prevent starting if the sieve is not in position.
With the sieve in position, make sure that the switch located
under the grinding chamber is turned on.
The manufacturer and keeper of technical documentation AMA S.p.A. Via
Puccini, 28 – 42018 San Martino in Rio (RE) Italy
declares under its own responsibility the following product:
Electric mill for cereals Zootechnical use
2006/42/CE, 2014/30/UE, 2011/65/CE, EN ISO 12100:2010,
EN 60335-1:2012+A1/A2/A14:2019, EN 55014-1:2017
San Martino in Rio, li 01/03/2020
All the machines manufactured by AMA S.p.A. are subject to ongoing development. We reserve the right to add any
improvements without notice and without update obligations.

DECLARATION OF CONFORMITY

Mod. EMC50-EMC55-EMC55X-EMC60-EMC70
from serial n° 00001 year 2020
IS COMPLIANT TO THE FOLLOWING DIRECTIVES:
9. SCRAPPING
Do not discard this in the environment! Should decide
to stop using the machine once and for all, the various
parts should be disassembled after disconnecting the unit
from the power Each piece should then be placed in its
proper container for
accordance with applicable regulations.
To the reduced consumption of dangerous elements
in electric and electronic equipment, and disposal of
rubbish. Information to the user pursuant to Directive
2012/19 / EU relating to the disposal of electrical and
electronic equipment.
The crossed bin on the equipment indicates you have to collect
the product, once it has come to its, end throw it away in
places suitable for electric and electronic devices, separately
from other waste.
FOR FURTHER DETAILS ABOUT THE ELECTRIC MILL, REFER
TO THE EXPLODED VIEW AND WIRING DIAGRAM.
9
pre-sorted waste collection in
THE PRESIDENT
Luciano Malavolti
GB