Features & Controls; Icon Touch Controls - Zephyr Roma Groove ZRG-E30BS Guide D'utilisation, D'entretien Et D'installation

Features & Controls

ICON Touch Controls

Power / Delay O
1 POWER / DELAY OFF BUTTON
Power Button Function
- Button will turn power on and o for entire hood (fan and lights).
- Hood will remember the last speed and light level it was turned o at.
(Example: Press
Press Button again and the hood will turn back on at speed 4 and high lights
level.)
Delay O Button Function
- With the fan on press and hold the
to speed 1 and the 5 minute delay o timer will start.
+
accordance with the time remaining until the fan and lights automatically turn
o .
- Pressing Button while Delay O Function is enabled will turn the hood o and
cancel the Delay O Function.
ACT™ Verification
- Airflow Control Technology (ACT™) allows the installer to set the maximum fan
CFM to align with local codes and regulations.
- To verify the maximum fan CFM:
- With hood o , hold the
indicators illuminate = default maximum CFM. If four fan speed indicators
illuminate = 390 maximum CFM. If 3 fan speed indicators illuminate = 290
maximum CFM.
2 SPEED SELECTION BUTTON
Fan Speed Decrease Button
- Press this button to decrease fan speed. 5, 4, 3, 2, 1.
- If fan is On Speed 1 and this button is pressed, fan will power O .
Fan Speed Increase Button
- Press this button to increase fan speed. Fan On, 1, 2, 3, 4, 5.
- If hood is O and this button is pressed, fan will turn On Speed 1.
ACT™ Enabled Speed Selections
- When ACT™ is enabled, the number of fan speeds will be reduced as follows:
- 390 CFM = Maximum 4 speeds
- 290 CFM = Maximum 3 speeds
18
Adjust 5 Speed Levels
Display (speed level, delay o , filter clean/change)
Button to turn o hood when on fan speed 4 and high lights.
Button for two seconds. The fan will change
LEDs will illuminate and slowly blink in
Button for two seconds. If all five fan speed
Roma Groove Use, Care, and Installation Guide
R O M A G R O O V E
Lights Low/High/O
C O R E
WA L L