Ridea 101. FLOWER POWER Notice De Montage page 9

 Make sure that the PH of the water is between 6,5 and 8,0.
 Make sure that the level of water hardness is between 12.0 and 14.0°f
 Bleed the radiator before use by means of the air valve.
 If any fault occurs, contact your local dealer. Do not tamper with the radiator;
any dismantling or opening operations undermine product safety. Ridea S.r.l.
declines all responsibility for accidents due to tampering with the radiator.
 Children must be supervised to ensure they do not play with the appliance.
 Clean with a damp cloth. Do not use aggressive or abrasive detergents that
could damage the paintwork on the appliance
 In models with towel rails, do not overload the structures with too much
weight. These structures are designed to carry a maximum load of 2 kg.
 In models with towel rails, the distance of these elements from the floor must
be 60 cm as a minimum.
 This radiator must be installed as part of a centralised heating system, which
has been cleaned/washed and contains circuit water with the addition of
inhibitors, in compliance with UNI-CTI 8065 or BS7593.
3. ASSEMBLY INSTRUCTIONS
ATTENTION!!
Read carefully all the instructions and the procedures to be
followed to assemble the radiator, as stated in the technical page
of the catalogue which is reproduced in this document in fig. 1.
3.1 The water inlet and outlet connections can be placed at any distance from the
floor, but make sure that the distance between the floor and the lower part of the
radiator is at least 10 cm. The water inlet and outlet connections should have a
centre distance of 5 cm for copper and multilayer pipes, 8 cm for threaded iron
pipes (fig. 1).
3.2 Assemble the supports and secure them to the wall as described in fig. 2
using plugs that are suitable to type of wall, and sturdy enough to anchor the
radiator to the wall. The radiators are supplied as standard with 8mm diameter
plugs for reinforced concrete. Fixing distances and centre distances depend on
the model purchased. Comply with the measures shown on the drawing and listed
in the table in fig. 1.
3.3 Hang the radiator from supports fastened to the wall with the plugs, and
secure it with the screws supplied as standard as shown in fig. 2. Make sure that
the supports are arranged as accurately as possible, if necessary, adjust the