Oceanic OCEAISHGB1000W2 Guide D'utilisation page 27

• If the power cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• The heater must not be located immediately
below a socket-outlet
•
WARNINGS
overheating, do not cover the heater.
• The device must be powered by a Residual
Current Device (RCD) with a rated operating
differential current of not more than 30 mA.
• Warning: if this appliance is installed in a
bathroom, it must be installed at least 60 cm from
a bath or shower (volume 2), in accordance with
the requirements of the French electrical
installation standard NFC 15 -100.
• The device must be connected to a circuit
independent electric protected by a bipolar circuit
breaker according to the standard electrical
installation NF C 15-100.
• WARNING: The heater must not be used if the
glass panels are damaged.
• Means for disconnection from the supply mains
having a contact separation in all poles must be
incorporated in the fixed wiring in accordance
with the wiring rules.
• With respect to the details of how to install the
appliance
"INSTALLATION" section.
• Regarding the detailed information on the
connection of the electric cable, refer to the
section "ELECTRICAL CONNECTION".
： In
onto the
Page 25 of 44
order
wall, refer
to avoid
to the