Connection To The Water Supply - WAHLBACH Mini Elex 3.5 Instructions De Montage Et D'utilisation

DE GB NL FR
Environment
This device is delivered in sturdy packaging in order to avoid damage during trans-
port. This packaging consists mainly of recyclable materials. We request that you
dispose of the packaging accordingly for recycling.
Installation
The device should be installed in accordance with the drawing on the first page
of the user manual. Any other installation position may result in serious damage
to the device. Installation should take place as close as possible to a cold water
connection. The product should be protected from the effects of frost (for ex-
ample in caravans, summer houses, etc.). The device may be installed above
(OT) or under (UT) the worktop.

Connection to the water supply

Frost
The device should be installed in a vertical position in a room
protected from frost and in the proximity of the water connec-
tions. In case the room cannot be protected against frost, the
device should not be installed in this room. Should the device
be installed in such a room, the device should be emptied be-
fore the frost danger will occur.
If the mains water supply pressure exceeds 5 bars, a pressure
restrictor must be fitted in the feed pipe. At the spout
of the tap only a strainer (supplied with tap) can be installed,
whereas a normal aerator or restrictor is prohibited.
Incorrect usage of this equipment (e.g. garden hose), or usage
of a tap that is not meant for low pressure installations may
cause pressure build-up in the device that might lead to dam-
age and thereby void the warranty!
If the mains water supply pressure exceeds 5 bars, a pres-
sure restrictor must be fitted in the feed pipe. At the spout of
the tap only a strainer (normally supplied with a low-pressure
tap) can be installed, whereas a normal aerator or restrictor is
prohibited.
14