Technical Data - Adler europe AD 2922 Mode D'emploi

because water proximity presents risk, even if the device is turned off.
16. Do not allow the device or power adaptor to wet.
17. If the device falls into water, immediately remove the power plug or power adaptor from
the socket. If the device is powered, do not put hands in the water. Have the device
checked by the qualified electrician before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. Never use this device close to water, e.g.: under shower, in bathtube, or above
sink filled with water.
20. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
21. The shaver charging temperature should not be above 35 degrees Celsius or below 5
degrees Celsius.
22. Do not use towel or paper tissues for cleaning of shaver head, as they can damage the
head.
Product description:
1. Blade 2. Blade hitch 3. Charging socket 4. Power indicator 5. On switch
6. 3 caps on the blade 7. Charging cable
First use:
1. Make sure that the device is fully charged before turning it on
2 If it is not charged, insert in the charging socket (3) the charging cable (7) and then connect to the power supply. The first charging will
take approximately 4 hours.
3. The power indicator (4) turns red and turns off when the device is charged.
NOTE: Do not use the device if it is still connected to a power source.
5. When fully charged, the device operates continuously for around 45 minutes.
WARNING:
The device is adapted to face facial hair: Beards, mustaches and sideburns.
Do not use the device to shave the head and intimate hair.
The device is designed to be used only dry, do not use in the shower or clean the blade in water.
Do not use with foam or shaving gel.
Using the device:
1. Apply the blade to the face so that the flat surface of the blades rests flat against your face. For best results, the movement of the
blade should be carried out in the opposite direction of hair. (The sensation of heat coming from the head is normal)
Attaching the overlay:
1. Make sure that the device is turned off.
2. select one of the provided overlays.(6)
3. Apply the cover with the teeth pointing up.
4. Gently press until both sides of the overlay snap into place, which will be signaled with a click.
Styling facial hair:
1. Do not move the shaver too fast. Slow and steady movements give the best results.
2. Always bend the overlay towards the teeth, making sure that the flat part of the cover adheres well to the face.
3. For best results use when skin and hair are completely dry.
Blade replacement:
For the best effect, please replace the blade every 4 months or earlier if the blade is blunt.
1. Remove any covers.
2. Gently press the blade hook (Figure 7) by pressing up until the blade slides.
3. Grasp the new blade by the sides and push in place of the old one. If properly installed, you should hear a click.
Note: After the replacement, if the blade does not work after switching on, remove the blade, turn the device on for a moment and re-
attach the blade.

TECHNICAL DATA

Charger voltage: 5V 1A
Max power.: 5 W Nom. Power: 0,25W
4