Trouble Shooting; Environmental Protection; Available Accessories - Jet JWL-1840EVS Mode D'emploi

When reinstalling handwheel, thread it on to the spindle
until its snug. Then back off slightly and tighten the set
screws.
Note:
To remove the pulley for bearing replacement it is needed
to loosen the 2 set screws (E).
Make sure the pulleys are oriented properly after
reassembly for straight belt running.

9. Trouble shooting

Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload detected on AC-drive unit-
wait and restart machine; chose low speed range belt
setting (40-1200 rpm) for better spindle torque.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*Workpiece is not properly centred
*The speed is too high
Tailstock moves
*Cam lock nut needs adjusting-
Tighten cam lock nut.
*Bed and tailstock mating surfaces greasy or oily-
Remove tailstock and clean surfaces
*Excessive pressure applied-
Slide tailstock to right side of lathe against stop (N, Fig 10).
Move headstock into position and then apply pressure.

10. Environmental protection

Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.

11. Available accessories

Stock number 719401
Bed extension 508mm with tool post extension
Stock number 719001
Tailstock swing away
Stock number 719002
Cage guard
Stock number 719601
Sample comparator kit
Stock number 708331
Live centre MT2
Stock number 708343K
Drill chuck 13 mm, with tapered mandrel MT-2
Stock number 709911
Face plate 75mm, M33x3.5
Stock number 709942
Four toothed spur centre MT2
Stock number 708349
Heavy outboard turning stand