Use; Assembling The Hand Blender; Use The Hand Blender; Using The Balloon Whisk Attachment - Cuisinart CSB801E Instructions

3 USE

The hand blender lets you mix and blend while adding as little
air as possible to your preparation All you need to do is move it
slightly up and down to prepare the tastiest of recipes To prevent
splashes, never remove the hand blender from your preparation
while it is running
A. ASSEMBLING THE HAND BLENDER
• To attach the blender shaft, line it up with the body and twist in
a clockwise direction to lock into place
• Plug the unit into the mains.
B. USE THE HAND BLENDER
• Place the blender into the preparation to be mixed while
ensuring that the base of the shaft is sufficiently immersed
• Select the lowest speed, press and hold the ON button (
The blender will continue to operate as long as the button
is pressed During operation, increase the speed if necessary
• Always begin by using the lowest speed, then turn the ring
toward the '+' to increase the speed
• By pressing the 'Turbo' button, you can attain the highest
operating speed You can also use this button in short bursts
during operation, working in pulses, without touching the
speed variator (see figure 1)
Minimum speed
14_CSB801E_IB_RC.indd 15
Maximum speed
figure 1
• To stop the blender, release the ON (
• Unplug the unit after use.
N.B. Do not hold the button on for longer than 60 seconds at a
time
C. USING THE BALLOON WHISK ATTACHMENT
• To attach the balloon whisk, align the motor housing with the
adaptor and turn the adaptor anti-clockwise to secure into place
• Align the end of the stainless steel whisk attachment with either
opening of the adapter
• Push end into opening until it locks into position.
• Plug into the mains.
• Place the appliance into mixture that will be whisked.
• With the speed dial set to minimum, press and hold the ON/
OFF button The appliance will continue to run as long as the
switch is pressed in To turn the appliance off, release the ON/
OFF button and the motor will stop
• Use the variable speed control dial on top of the motor housing
)
to increase the speed For an extra burst of power, press the
"Turbo" button on the front of the housing above the ON/OFF
button
• Unplug immediately after use.
) or turbo button
15
9/10/14 10:02