Tape Dubbing - Sharp 13VT-CR10 Mode D'emploi

Tape Dubbing

Your TV/ VCR COMBINATION can dub (copy) video material from another video device.
The connections are shown below. Begin recording on the TV and playback on the source VCR simultaneously.
Video Connection
1. At the Source VCR
• Insert a pre-recorded tape.
2. At the TV/ VCR
• Insert a blank tape.
3. Choose Input Source
• Either pressing of INPUT or CHANNEL UP/DOWN (8/9) buttons on the TV/ VCR set or Remote Control can be used to
select the channel.
(Pictures and sounds inputted through VIDEO IN/AUDIO IN can be played back on the INPUT channel.)
4. Play Back the Tape
• Press the PLAY button on the source video equipment.
5. Record (Copy) the Tape
• Press the REC button.
Note:
• When connecting video or audio equipment to the television, be sure that the power is turned off in order to prevent damage
to either the television or the equipment being connected.
• It is the intent of SHARP that this product be used in full compliance with the copyright law of the United States and that prior
permission be obtained from copyright owners whenever necessary.
• For detailed information on the connection and use of auxiliary equipment, refer to the instruction manuals of the equipment
being used.
• The connection cables can be obtained from your local video source.
20
20-22 13VT-CR10[E].pm65e
Downloaded from: http://www.usersmanualguide.com/
FRONT
FROM VIDEO SOURCE; To VIDEO OUT
CAMCORDER
20
POWER POWER/
WAKE-UP
PROGRAM TAMPER
TIMER REC
TIMER PROOF
VIDEO IN
REV FWD
VCR DVD
VIDEO EQUIPMENT
AUDIO IN
To AUDIO OUT
TV GAME
15/5/01, 7:25 pm