Hahnel CAPTUR Mode D'emploi page 7

BULB Mode
Select BULB mode on camera. Press and hold the
Release Button
flashes red =
shutter. For more advanced timed BULB shooting use the
and
Interval Timer Programmable Functions
Press
Start/Stop
Photography'. The Captur Module - Timer will now take a
photo continuously at the factory set interval time. Press
Start/Stop
The values of the following parameters can be adjusted as
required. Use
the parameters which need to be adjusted. Press SET button
to adjusted parameters.
14
to adjust the value of the parameters. Press SET button
again to confirm adjustment.
Parameters
3
4
5
6
7
Digital Channel Matching – DCM
a. Timer - Press and hold
flash green
b. Receiver - Press and hold button + Turn 'ON'. LED will show
steady red
c. DCM is complete. Turn both Timer & Receiver 'OFF' and
'ON' to reboot
Note: For multiple Receivers repeat step 'b' for all receivers without
turning off timer
Camera & Flash Remote Control
Requires an additional Captur receiver and Transmitter which
are synced on a differnet channel.
Captur - Timer Kit
to open the shutter - after 3secs timer LED
. Full press
settings.
button to 'Start' the 'Interval Timed
again to 'Stop' the interval timed photography.
Toggle Button
Description
Delay before 1st shutter
is released
Burst/Bulb time
1st Interval Time
= Number of
shots for 1st Interval
= Number of
times program is
repeated
2nd Interval Time
Release Button
< or > to move between
15
Toggle Button
Setting
0s to max 99hrs 59'min
59"s (in 1s increments)
1s to max 99hrs 59'min
59"s (in 1s increments)
1 to 999 and ---
(unlimited)
1s to max 99hrs 59'min
59"s (in 1s increments)
Release Button
= to close
+ or - is used
15
14
+ Turn 'ON'. LED will
7