Hahnel CAPTUR Mode D'emploi page 6

Captur Module - Timer
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Setting up Captur - Timer Kit
The Captur Module - Timer is used with the Captur Receiver
to control the camera wirelessly. Alternatively you can also
connect the Captur Module - Timer directly to a DSLR camera
with the camera cable included.
Single Shot Mode
Select single shot
similarly to the camera shutter release. ½ push = Autofocus,
LED shows steady green. Full push = Shutter release, LED
13
shows red.
13
Continuous Shot Mode
Select continuous mode
Release Button
press
Release Button
6
Sound ON/OFF
Button Lock
Delay before shooting starts
Duration of burst/exposure with
continuous/bulb
1st Interval time
Number of shots at 1st Interval
Number of times
program is repeated
2nd Interval time
Low battery indicator
Hours
Minutes
Seconds
Shot count 0 to 999, --- (unlimited)
Shutter release LED
SET button
Toggle Button
on camera. The
- after 3secs timer LED flashes red =
=
Release Button
on camera. Press and hold the
works
. Full
Captur - Timer Kit