Rola TX-102 Guide D'instructions page 5

PROPER USAGE
FOLDING CARRIER FOR HATCH/TRUNK CLEARANCE
1. Securely hold main support tube (A) and remove bail pin. FIG 5.
2. Lower the main support tube slowly until it is on the collar bracket.
NOTE: Do not drop or let the main support tube fall freely. Make sure
that your hands and fingers are clear of the hinging areas during this
operation.
3. To restore the carrier to the upright position, reverse procedure.
BIKE LOADING INSTRUCTIONS
1. Once carrier is secured to vehicle, bikes can be loaded onto the rack.
Alternate each bike, with the anti-sway cradle being closest to the
seat tube. FIG 6.
2. Secure the bikes by pulling the straps over the top of the bike frame.
FIG 6. The anti-sway straps wrap around the seat tube and prevent the
bike from swaying. FIG 7.
3. Check the straps periodically, and after stopping, to ensure that they
are still tight and that someone has not released them.
NOTE: Ensure all locks are locked, that all pins are secured, and that
all straps are properly attached prior to moving the vehicle. Failure to
do so will void warranty.
LOCKING BIKES
1. Once carrier and bikes are secured to vehicle, lock can be routed
between bike frames and secured to the stud on the right arm.
2. Once unlocked, lock cable can be pushed back into the support tube
for storage. FIG 7.
All manuals and user guides at all-guides.com
PAGE 5
5
6
Anti-Sway
Cradle
7
Anti-Sway Cradle
FIG 5
Lock
Lock Stud
Anti-Sway
Straps
59400/59403_IN_Rev A • Questions? (800) 234-6992 • RolaProducts.com
A
Main Support Tube
Remove Bail Pin
Anti-Sway Strap
Seat Tube
An#-­‐Sway C radle