Rola TX-102 Guide D'instructions page 3

ASSEMBLY INSTRUCTIONS
TO ATTACH MAIN SUPPORT TUBE TO COLLAR BRACKET:
1. Pull bail pin from collar bracket (B). FIG 1.
2. Insert bushings (C) into main support tube (A). Then, connect main
support tube (A) to collar bracket (B) as shown in FIG 1. Align bushing
hole with lower hole in collar bracket and install one (1) ½-13x3-½" lg.
hex bolt (F), two (2) ½" flat washers (D), and ½" locknuts (G) as shown.
Tighten ½" locknut until some resistance is felt when rotating main
support tube. Align remaining hole in main support tube with hole in
collar bracket and install bail pin.
All manuals and user guides at all-guides.com
PAGE 3
1
Bail Pin
F
B
D
Lower Hole
59400/59403_IN_Rev A • Questions? (800) 234-6992 • RolaProducts.com
A
C
Bushings
D G