Dosteba SLK-ALU-TR Mode D'emploi page 10

Drilling gauge and setting gauge
Instruction
Dosteba AG, CH-8184 Bachenbülach, Tel. +41 43 277 66 00, Fax +41 43 277 66 11, dosteba@dosteba.ch
First mark borehole and then bore.
For the drilling gauge for SLK
positioning bolt into the corresponding hole.
Using the drilling gauge for SLK
second hole.
For the drilling gauge for SLK
second positioning bolt into the corresponding hole.
Using the drilling gauge for SLK
third and forth hole.
Position the threaded rods and align them exactly
using the setting gauge for SLK
gauge for SLK ® -ALU-TQ.
Let the injection mortar harden. After hardening, pull
out the setting gauge.
-ALU-TR / -TQ, insert a
®
® -ALU-TR / -TQ drill a
-ALU-TR / -TQ, insert a
®
® -ALU-TR / -TQ drill a
® -ALU-TR or setting
Page 10