Installation Rules - Vimar ELVOX 41016 Manuel Installateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
41016
Using this digital fingerprint reader correctly will ensure good
results:
- You are advised to use the finger which you think has
the best fingerprint lines. In particular, with poorly visi-
ble fingerprint lines you are advised to press down more
lightly, so as not to flatten the lines and ensure correct
recognition.
- Do not use the little finger or thumb.
- The fingerprint reader has an automatic learning system,
which recognises changes in the user's habits and the
growth of children's fingers, to improve recognition over
time.
- To optimise the digital fingerprint recognition, each time
a new fingerprint is saved or the system has not be used
for long periods of time, perform at least five recognitions.
If on any of the scans the finger is not recognised, repeat
the recording procedure.
If none of the digital fingerprint scans are accepted, do as
follows:
- Record the same fingerprint with your finger in several
different positions, in order to increase the likelihood of
recognition. In extreme cases, use up to 10 recordings of
the same fingerprint.
- Wet fingers vary the state of the fingerprint. If you often
have wet fingers, record the finger also when wet.
- Children's fingerprints are generally recognisable, de-
pending on their size, usually from age five upwards.
The instruction manual is downloadable from the site www.
vimar.com

Installation rules

Installation should be carried out by qualified personnel
in compliance with the current regulations regarding the
installation of electrical equipment in the country where
the products are installed.
Conformity
EMC directive. RoHS directive.
Standards EN 62368-1, EN 61000-6-1, EN 61000-6-3
and EN IEC 63000.
REACH (EU) Regulation no. 1907/2006 – Art.33. The
product may contain traces of lead.
WEEE - Information for users
If the crossed-out bin symbol appears on the
equipment or packaging, this means the product must
not be included with other general waste at the end of
its working life. The user must take the worn product to a sorted
waste center, or return it to the retailer when purchasing a new
one. Products for disposal can be consigned free of charge
(without any new purchase obligation) to retailers with a
sales area of at least 400m
An efficient sorted waste collection for the environmentally
friendly disposal of the used device, or its subsequent
recycling, helps avoid the potential negative effects on the
environment and people's health, and encourages the re-use
and/or recycling of the construction materials.
EN
, if they measure less than 25cm.
2
9

Publicité

Table des Matières
loading

Table des Matières