Problem Solving - GBC WIRE BINDER G1 Manuel D'instructions Et D'utilisation

9. PROBLEM SOLVING

A. Common Problems:
Problem Probable Cause
No power, No Power cord not attached to back of machine or
not properly plugged into the wall.
Operation
Power On/Off Switch not activated
Close Ensure that the doors and cover are properly
Door/Close closed and latched. Press the door or cover
Tray/Close firmly into
Cover message repeatedly, adjust the Interlock flag.
appears
Twin-Loop wire Avoid damage to the spool by taking care during
jamming storage and loading.
repeatedly
Remove the excess wire and re-feed wire into
the element feed module. Follow the installation
instructions in Section 4.
If necessary, remove a length of wire from the
spool and reinstall the spool.
Sheets Confirm that an appropriate BINDER G1 die is
jamming installed on the PUNCH G2. Using an unbound
repeatedly on sheet, confirm the punched hole accuracy using
the Stacking the guidelines in Section 9 C-D. If the accuracy
area (Area 2)
of the punched holes is not in spec, make
adjustments to the punch alignment settings. If
J202, J203,
problem persists, contact service.
J244
Wire jamming J361 jams on the BINDER G1 may be caused
in feeder. (Area by dust on the film cover on the element sensor
3A)
(S22). Clean the film by wiping a dry cloth
across the film covering the element sensor
J361
shown below.
J361 jams can also be caused by the wire end
being positioned incorrectly when installing a
spool. Refer to Section 7 B step 16.
Broken carrier If the carrier paper between the wire spool and
paper rewind spool breaks, empty the rewind spool of
carrier paper and reattach the loose end from
the spool to the rewind spool hub, then follow
the spool installation steps starting on step 12.
You may need to cut off the excess wire if there
is too much slack in it.
place. If message appears
Broken carrier Alternatively, you can repair the carrier paper
paper after emptying the rewind spool hub. Using a
discarded length of carrier paper, secure one
end to the rewind spool and cut it to length so
that there is enough for 2 inches (50mm) of
overlap with the paper end still attached to the
spool.
packaging tape or secure with 3 staples then
follow the spool installation steps starting on
step 12.
Broken carrier
paper
(continued)
Wire failing to J320 jams on the BINDER G1 may be caused
trigger slack by the carrier paper between the wire spool and
sensor. (Area rewind
3A) entangled on the wire. Refer to Section 7 B
steps 1-5 and steps 11-19 for reinstalling the
J320
spool. Note: It may be necessary to trim off
excess wire if the length of carrier paper is not
sufficient to reach the rewind spool or if the wire
has been damaged by stretching.
J320 jams on the BINDER G1 may also be
caused by debris collecting on the element slack
sensor and restricting its motion. Clear the
debris with a cloth or vacuum. Compressed air
can be used to clear the area under the flapper
as well.
Full Rewind J320 jams can occur when the rewind spool
Spool becomes too full. The rewind spool has a
window cut into it. When paper reaches this
J320
window, cut the paper where it leave the rewind
spool and perform steps 16-17 in Section 7 A to
empty the hub and then reattach the cut end to
the now empty spool
Poor closing or Poor closing and stacking can occur for A5 and
stacking with statement size books if the book drawer bar not
A5 or statement is not installed properly. Check that the bar is
books installed properly. Refer to Section 6.
14
WIRE BINDER G1
Wrap the overlapped section
spool breaking or by
GB
in
becoming