Normal Operation; Basic Programming - Pentair Fleck 5812 SXT Mode D'emploi

User Guide Fleck 5812-SXT
3.3. Description and components location
3.4. By-passing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.

Normal operation

Softening system
In
4 . Programming
Note:
The controller must be plugged to be programmed.
After 5 minutes without any button pressed, the unit returns to normal operation without saving.
4.1.

Basic programming

Note:
Menus are displayed in a defined and incremental order.
Day of Override
Note:
Determine the maximum number of days of operation without regeneration.
Regeneration time
A
Press and
B
Select the number of days of Override with
C
Press o validate the selection and advance to the next parameter.
t
Note:
Determine the time of regeneration.
D
Adjust the regeneration time with
E
Press t o validate the selection and advance to the next parameter.
6 / 36
Regeneration button
Up button
Display
Down button
Mixing device
Out
simultaneously for 5 seconds to enter the menus sequence.
and
and .
.
Drain
Brine
Meter
Inlet
Outlet
In Bypass
Softening system
In Out
Ref. MKT-UG-017 / C - 14.10.2019