JANE Baby Side Mode D'emploi page 12

INSTRUCTIONS
Assembling and dismantling the co-sleeping mini cot:
· To assemble the cot place the upper frame with the upholstery on a clean table or on a bed as shown in diagram 2.
· Position each of the side legs always with the height numeration on the external side, and insert the end of each leg
into the side support of the plastic until the metal pin pops out through the hole (it will click) and the plastic side legs are
slotted into the holes.
· You should hear the safety clicks.
2
A
PIN OK
A CLIP OK
"CLICK"
"CLICK"
· Fit the long bar by inserting each end into the plastic slots until the metal pin pops out again. You should hear the safety
clicks. Then place the structure with the wheels on the oor.
"CLICK"
"CLICK"
"CLICK"
· Lastly, position the lower frame so that the side ends are aligned with the holes halfway up the sides of the mini cot, and
then fully insert each end inwards with a gentle tap until you hear the safety clicks.
B
A
Check that the 2 plastic
supports A and B face
upwards
12 12