Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Trunk
Pan
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 24755F or 60814F
Wrenches: 3/4", 10mm
Drill Bits: 1/2"
Drilled
Holes
1
Qty. (1)
Hex Bolt, 1/2"-13 x 2-1/2"
2
Qty. (3)
Spacer, 1/4" x 1-1/2" x 2"
3
Qty. (3)
Lock Washer, 1/2"
1.
Remove the spare tire from the trunk.
2.
Remove plastic cover under trunk by removing four plastic rivets connecting it to the fascia and two hex flange nuts connecting
it to the trunk bottom. Reinstall the rivets and return the plastic cover and hex flange nuts to the vehicle owner.
3.
Attach hitch to tow hook as shown in Figure 1. Orient the spacers with respect to the tow hook as shown in Figure 2 and
Figure 3.
4.
Using the hitch as a template, drill two 1/2" holes in the trunk pan.
5.
Install the hitch to the trunk pan with the carriage bolts, spacers, lock washers and nuts as shown in Figure 1.
6.
Seal the holes drilled in the trunk pan to prevent intrusion of exhaust fumes and water.
7.
Reinstall the spare tire in the trunk.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Installation Instructions
Acura TL
Fascia
Drawbar Kit:
Tow
3594
Hook
Or
6809
Drawbar must be used in the
RISE position only.
Figure 1
Tighten all 1/2" GR5 fasteners with torque wrench to 75 Lb.-Ft.
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
2000 LB Max Gross Trailer Weight
200 LB Max Tongue Weight
Wiring Access Location: PC3, PC4
Trunk Pan
Tow Hook
4
Qty. (3)
Hex Nut, 1/2"
5
Qty. (2)
Carriage Bolt, 1/2"-13 x 1-3/4"
6
Qty. (2)
Spacer, 1/4" x 1" x 2"
24755N
Part Numbers:
24755
77131
60814
Manufacturer's Rating or
REMOVE SPARE TIRE
BEFORE DRILLING
Tow
Hook
Figure 2
Trunk
Pan
Tow Hook
Orient Spacers As Shown
Figure 3
08-25-05
Rev. A
Publicité
Manuels Connexes pour Cequent Towing Products 24755
Sommaire des Matières pour Cequent Towing Products 24755
- Page 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 24755N 08-25-05 Rev. A 2005 Cequent Towing Products...
- Page 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 1 de 3 24755N 08-25-05 Rev. A 2005 Cequent Towing Products...
- Page 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York. V.E.S.C. Regulación V-5 y SAE J684 Hoja 1 de 3 24755N 08-25-05 Rev. A 2005 Cequent Towing Products...