Publicité
Les langues disponibles
Les langues disponibles
1. Lower muffler – Using the exhaust removal pliers, lower muffler by
removing the (4) rearmost rubber hangers. There are (2) hangers on the
left side of the exhaust, (1) on the right side of the exhaust, and (1) in the
middle of the car. Note: A spray of lubricant on rubber hangers makes
them slide off metal pins more easily. NOTE: Be careful that exhaust is
supported before removing rubber hangers.
3. Install fasteners – Feed the coiled end of pull wire through the rearmost attachment hole and out of the forward most access and attachment hole in the
bottom of frame. Attach the 7/16" carriage bolt and spacer (item 4) to the pull wire and pull the fasteners into position, both sides. See figure 2. Using the
provided pull wire, complete the reverse fishwire technique as seen in figure 3.
©2017, 2020 Horizon Global Americas Inc. - Printed in Mexico
2. Remove rubber plugs -- Using a flat screw driver, remove (2) rubber
plugs, rear and forward, from the holes in the bottom of the frame on each
side of the car, return plugs to customer. Using a utility knife, remove the
excess caulk near the access hole. Note: Reseal if seam is exposed.
Sheet 4 of 15
36644NP
07-14-20
Rev. B
Publicité
