Imetec M3001 Instructions Pour L'emploi page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
• Before connecting the appliance, please make sure
that the voltage data indicated on the identification
technical data (5) correspond to those of the mains
voltage. The identification technical data are found on
the appliance (5).
• This appliance must only be used for the purpose for
which it was designed, namely, as a hair dryer for home
use. Any other use is considered not compliant and
therefore dangerous.
• When the appliance is used in a bathroom, unplug it
after use since the proximity of water presents a hazard
even when the appliance is switched off.
• For additional protection, the installation of a residual
current device (RCD) having a rated residual operating
current not exceeding 30 mA (ideal 10 mA) is advisable
in the electrical circuit supplying the bathroom. Ask
your installer for advice.
WARNING: Do not use this appliance near
bathtubs, showers, basins or other vessels
containing water.
Never place the appliance in water.
• This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children
must not play with the appliance. Cleaning and user
maintenance shall not be made by children without
supervision.
Do NOT use the appliance with wet hands, damp feet
or barefoot.
Do NOT pull the power cable or the appliance itself
to remove the plug from the socket.
Do NOT expose the appliance to humidity or weather
conditions (rain, sun, etc.).
• Always disconnect the appliance from the mains supply
before cleaning or performing maintenance and when
the appliance is not in use.
• If the appliance is faulty or malfunctions, switch it off
and do not tamper with it. Any repairs must only be
carried out by an authorised technical service centre.
• If the power cable is damaged it must be replaced by
an authorised technical service centre, so as to prevent
5

Publicité

Table des Matières
loading

Table des Matières