Philips sonicare 9000 Serie Mode D'emploi page 33

2 Remove and discard the brush head. Cover the
3 Hold the top of the handle with one hand and
1
2
4 Remove the end cap from the toothbrush
5 Holding the handle upside down, press the
6 Wedge the screwdriver between the battery
entire handle with a towel or cloth.
strike the handle housing 0.5 inch above the
bottom end. Strike firmly with a hammer on all
4 sides to eject the end cap.
Note: You may have to hit on the end several
times to break the internal snap connections.
handle. If the end cap does not release easily
from the housing, repeat step 3 until the end
cap is released.
shaft down on a hard surface. If the internal
components do not easily release from the
housing, repeat step 3 until the internal
components are released.
and the black frame at the bottom of the
internal components. Then pry the screwdriver
away from the battery to break the bottom of
the black frame.
33
English